1. Drilling: Before drilling, carefully observe the wiring layout of the plumbing and electrical lines to avoid errors. The spacing between drill holes should not be too large, otherwise the baseboard will not adhere properly to the wall.
Use a special tool to drill holes in the wall. Baseboards are typically 2 meters long. To ensure a more secure fit, the spacing between drill holes should be approximately 40cm, with smaller spacing at joints. Insert small wooden strips into the drilled holes. The nails for securing the baseboard are then driven into these wooden strips. Directly nailing them to the wall can cause them to loosen.
Note: Since plumbing and electrical pipes are buried in the wall, and the area directly below switches and sockets is where the pipes are located, calculate the drilling positions carefully to avoid damage.
2. Fixing: Before fixing the baseboard, the wall surface must be leveled and cleaned. Otherwise, the baseboard will not adhere completely to the wall, leaving unsightly gaps.
Renovation Tips | Baseboard Installation Guide! Here's a guide to installing baseboards! First, locate the drilling positions and then secure the baseboard with nails. When securing, ensure the baseboard is flush against the wall, and the nails are completely embedded and invisible.
Note: Regardless of whether the baseboard is made of polymer, MDF, or wood, it expands and contracts with temperature changes. Therefore, like flooring, a 1cm expansion joint should be left at the corners.
3. Edge Treatment: At the corners where baseboards meet, the edges should be cut at a 45-degree angle to avoid unsightly marks. Secure the cut baseboards. Note: All baseboards at corners must be cut at a 45-degree angle before splicing and installation; otherwise, it will affect the aesthetics.
4. Installation Tips: Use specialized threaded nails to secure the baseboards for better fixation and to prevent loosening. Be wary of manufacturers cutting corners.
Baseboards are designed to conceal expansion joints in the floor, making the floor more aesthetically pleasing. Therefore, the edges where baseboards intersect should be planed smooth.
Baseboard installation details: For a beautiful finish, both walls and floors need to be properly prepared.
Baseboards should be completely flush with the wall without gaps for a more attractive look, especially at corners. The flatness of the wall should be tested before installation.
